FREE SHIPPING ON ORDERS OVER $100

.500 (.500) 350gr Round Shoulder

.500 (.500) 350gr Round Shoulder

$94.99$177.99

SKU: N/A

Berry’s Superior Plated Bullets® are the finest bonded copper-jacketed bullets available today. Starting with a swaged lead core, they are electroplated with copper to their final weight, leaving no lead exposure. They are then re-struck to precise specifications, ensuring a solid bond and providing consistency with every round. Indoor range safe and unbelievably accurate, Berry’s Superior Plated Bullets® are the choice of shooters everywhere.

**THIS IS NOT LOADED AMMUNITION**
**UNABLE TO SHIP THE PRODUCT TO THE STATE OF MASSACHUSETTS**

  • Bullet O.A.L.: .720"
  • Cartridge Name: 50 AE
  • Cartridge O.A.L.: 1.575"
  • Max Velocity: 2000 fps
  • Cartridge Name: 500 S&W
  • Cartridge O.A.L.: 2.100"
  • Max Velocity: 2000 fps
  • Load data for our Superior Plated Bullets® can be found in any manual or on any powder manufacturer’s website.
  • Cast or jacketed data with the same grain weight and profile will work with our bullets.
  • You can use a taper or a roll crimp.
  • Don’t over crimp the brass after seating. This causes bullet core separation, leading to increased copper fouling and accuracy issues.
  • Don’t exceed the recommended maximum velocities listed. This creates bullet core separation and accuracy issues.
  1. VSteed

    Great bullet I am using the .50 caliber 350 grain bullet for my 500 Smith and Wesson, starting load using data for 500 Special even at 1150 fps
    wonderful accuracy and plenty of juice for light load. I will be increasing power level to 500 magnum it’s been years but i want to enjoy and
    revisit this wonderful hobby. Thank you for proving a .50 caliber bullet at reasonable cost. I will be purchasing additional bullets for many calibers.

  2. Mike L

    I use these particular bullets for 12.7×42 (50 Beowulf), not saying you should, but it makes reloading that round some much more cost effective, not to mention the bullets fly great within a couple of moa at 100 yards out of a very reasonably priced gas gun, not bad at all. I did drill and tap a fired case and used a gauge to measure my jam length and adjusted seating depth making sure to fit the mag and not be jaming bullets into the rifling. I’ve used many of Berry’s bullets and I can’t complain about anything to this point. Great stuff so far.

Add a review

Your email address will not be published. Required fields are marked *

Top Rated Products

.45 (.452) 185gr Flat Point

Loaded up my first batch of these 185 grn FN and really like them. They feed just fine in all my guns and have amazing accuracy, ragged holes at 7 & 15 yds. Only reloading note, I had to seat…

7.62 x 39mm (.311) 123gr Spire Point

Getting ready to order my 2nd batch. These are great in my AK47, they are perfect for plinking and my rifle likes them. No cycle issues and having used more expensive bullets before seeing these, I can honestly say that…

9mm (.356) 115 gr Hollow Base Round Nose Thick Plate

I started out using the 1250 fps rated bullet and fired hundreds of rounds from my 1911 & SA-35s. I upgraded to the thick plate when I bought a PCC. The accuracy and fun factors are above reproach. Thousands of…